Mechanical Installation Contracting and Projects

Mechanical installation contracting and projects deliver the turnkey build of a building or plant's entire mechanical infrastructure — heating-cooling, ventilation, fire extinguishing, water-steam, compressed air, process and automation lines — from design through commissioning. Running parallel with architectural and structural decisions, the discipline unites capacity calculations, shaft-duct coordination, equipment selection, piping-insulation production, test-commissioning and operating documentation under single responsibility. The aim is meeting comfort and process conditions at sustainable cost, protecting life and property with redundancy, and handing the systems over with a passport ready for periodic inspection. KYF Test combines its periodic examination background with contracting discipline to catch bad design and workmanship before operation starts.

Service Components

• Industrial and comfort HVAC — heating, ventilation and air conditioning.
• Fire protection and extinguishing plus specialised kitchen hood and transformer suppression systems.
• Plumbing, hot oil-water-steam and compressed air installations.
• Automation, infrastructure and industrial process installations.

Project Engineering

A mechanical project starts with the load calculation: heating-cooling loads (per insulation rules TS 825), air-change rates, process heat needs and simultaneity assumptions are the first inputs. These are followed by hydraulic balancing (pressure independent control valves), fan-pump operating point selection, duct-shaft coordination and noise-static pressure control. On floor plans the systems are merged with clash detection; early coordination cuts the expensive site revisions. Equipment selection weighs operating energy (EER/SCOP, boiler efficiency, compressor specific power) and the N+1 redundancy rule for critical lines alongside first investment.

Production, Installation and Test Discipline

Site work runs on a quality plan built on welding procedures (WPS/PQR), hanger support calculations, expansion-compensation details and pressure tests. Duct leakage class, pipe insulation-vapour barrier integrity and fire damper-seal details at compartment passages are the key verification points. Commissioning is documented with balancing records, terminal unit tests, fan curve verification and setpoint consistency measurements. The resulting file feeds directly into the periodic inspection of installations regime — reference values are taken from this dossier.

Delivered Ready for Maintenance

Good contracting hides in the details that save operation's first year: access cover and service space planning, flow direction-painting-label standards, critical spare part lists and equipment maintenance cards. The discipline means a plant ready and safe for later thermal and pressure vessel inspections; clamp, insulation and alignment errors are corrected at mounting, not at maintenance time.

Legal Basis and Outcome

Projects run under Law No. 6331, the Regulation on Protection Against Fire in Buildings, the Occupational Health and Safety Regulation for Work Equipment (mandatory checks of steam and hot-oil boilers and pressure vessels) and the relevant TS/EN standard series. On the heat generation side, the periodic control needs of the steam boiler and hot oil boiler are planned together with the contracting scope. Contact us via the contact page for survey, preliminary design and quotation; this heading is offered under Contracting and Project Services.